how hot is too hot to be repaired?

label Other
account_circle Unassigned
schedule 3 Hours
account_balance_wallet $5


Hi, I was wondering how to know if my 1990 Toyota truck with the 3vze engine is worth fixing it overheated many times though after taking it apart it all looks pretty good I think the reason it lost power and refused to start may be because the timing belt slipped. please I would appreciate any thoughts on this

 

Oct 30th, 2013
It's because the 207 does not have gaurds over the disc, so they go rusty. ... All you can do is make sure you press hard on the brakes at least once on a journey! ... I have lost count how many times its been in the garage, this car is a total .... He also said the timing belt could have either stretched or slipped.
Oct 30th, 2013

are you talking to me usmanghani? if so I must tell you I am not talking about breaks I am talking about the engine


 

Oct 30th, 2013

3VZE Engine had bad rear oil seal leak. The seal has been repaired? The noise under load probably the rod bearings, Even if oil pressure good, that is first thing I'd check. If badly worn bearing(s) found ,the connecting rods should be resized and the crank machined.With the rod cap and bearing off the suspected crank journal, measure it twice 90 degrees apart. The measurements should be the same.Bearings are usually of a tri-metal construction, if copper shows, they are worn.The suspect bearings are often noticed by rocking them side to side before the caps are removed.

Hybrid12.pdf 

Oct 30th, 2013

Did you know? You can earn $20 for every friend you invite to Studypool!
Click here to
Refer a Friend
...
Oct 30th, 2013
...
Oct 30th, 2013
Oct 17th, 2017
check_circle
Mark as Final Answer
check_circle
Unmark as Final Answer
check_circle
Final Answer

Secure Information

Content will be erased after question is completed.

check_circle
Final Answer