1993 pickup

Other
Tutor: None Selected Time limit: 3 Days


my truck wont shift out of first and second gear into high gear what could the problem

 

Nov 6th, 2013
Hi sorry for the whole thing,
This could be caused by a few different things. Your upshifts are controlled by governing
Pressure and your downshifts are controlled by throttle pressure and here are the things You should check!
Check your throttle valve cable on the driver front side of the transmission. It connects a throttle valve lever. When the gas pedal is up the lever should be all the way forward and when you start pressing the pedal it should start moving rearward, The lever has a Return spring on it to return the lever to the front. Check this for binding/sticking and make Sure it works freely!
-Your governor pressure has to be monitored with a scan tool. In drive stopped the Governing pressure should be 0 psi and as you start accelerating the pressure should rise. see a scan tool along with a pressure gauge hooked to the governing pressure port on the
Right side of the transmission then compare it to make sure the sensor is working properly.
Governing solenoids are the most common part that fails with these. Transmissions. I always replace the solenoid along with the sensor if found faulty. They are Easy to replace you just have to pull the pan off to replace.
-Another thing it could be is a sticking valve in the valve body and the only way to repair it is to replace the valve body or have it rebuilt by a professional.
-Another thing you could check is the output speed sensor. This sensor tells the PCM the Output shaft speed of the transmission which is then used for governing pressure Calculations for the electronic governing. When the output speed sensor signal is missing There isn't any way to control the governing and it will normally stay in first gear without Attempting to up shift. The output speed sensor can be checked with a scan tool or an scilloscope. You can also check the resistance with an ohm meter to see if it is open or halted . The resistance should be around 580-700 ohms.
-Sometimes if your transmission won't up shift out of low until you get your revs and speed Lay up and then have to back off to get it to up shift you could have a front band that is way loose, broke or fallen apart. This will not allow a shift into second gear and it will go right From first to third. The front bands are the weakest part on these transmissions!
In case you can't fix it yourself I recommend a mechanic in order to avoid further damage.
Goodluck friend
Nov 6th, 2013

Studypool's Notebank makes it easy to buy and sell old notes, study guides, reviews, etc.
Click to visit
The Notebank
...
Nov 6th, 2013
...
Nov 6th, 2013
Dec 5th, 2016
check_circle
Mark as Final Answer
check_circle
Unmark as Final Answer
check_circle
Final Answer

Secure Information

Content will be erased after question is completed.

check_circle
Final Answer