1. Draw the isometric views (3D view) for the following multi-views in the dwg files.2. Add the dimensions and text to isometric.3. Submit them as one DWG and one PDF file.

below is the legal description of the property your client has purchased. You are asked to draw the property boundary based on the information provided herewith. Commence at South East Corner of SW ¼ of Section 7, Township 28 South, Range 19 East (point coordinate 357098.04, 1352651.49); thence N a distance of 56.97; thence W a distance of 851.79 feet to Point of Beginning; thence N 89d31'54" W a distance of 152.53 feet; Thence, N 0d16'54" E A distance of 233.95 feet; thence, S 89d29'25" E a distance of 152.47 feet; thence, S 0d16'5" W a distance of (approximately) 233.84 feet to Point of Beginning.1. Draw the legal description of the property in AutoCAD (17 Points).2. Label Point of Beginning and Point of Commencement (2 points each).3. Label the property line (4 Points)).4. Indicate the size of the property (5 Points).5. Insert the file attached Survey 1 dwg download at (0,0) insertion point (mandatory for the next three steps).6. Insert your title block, scale, a north arrow (5 points each).7. Project Name is [create a project name for yourself] (5 Points).8. What is the horizontal distance between the northeast property corner and Tallahassee? (10 Points).9. Submit both the DWG and PDF files.

Draw a closed end wrench Set UNITS as shownLength Type = DECIMAL precision=0.00 Set LIMITS as shown Lower Left = (0,0), Upper Right =(11,9) Create LAYERS outlined below (these may be different than what is shown in our Class Standard).Make LINEWEIGHT as shown in the table below.Draw figure as shown in PDF provided in the MIDTERM folder keep orientation Landscape.Draw figure in Model space to precise dimensions shown in PDF.Use dimensions provided to draw figure but do not add dimensions to drawing.Fill out the title block fully and completely.Create (1) Viewport in layout to show figure drawn in model space. Make sure your viewport is in the correct layer per our standard. Submit both drawing and PDF, Both must be submitted. If PDF or DWG file is missing you will be deducted 50 pts (half the possible points) leaving you with a maximum of 50 possible points for this portion of the test. So please submit both. Also, make sure you submit DWG file with the correct extension (drawing.dwg).