The failure reasons of clutch release bearing

Business & Finance
Price: $800 USD

Question description

1. The working conditions of the clutch release bearing and force

Release bearing in the process of using the axial load, impact load, and the effect of high-speed rotation of the radial centrifugal force, in addition, because the fork lift and separation of leverage reaction is not a straight line, also form a torque. Clutch release bearing poor working conditions, the intermittent high-speed rotation and high friction, high temperature, lubrication condition is bad, no cooling conditions.


2. The failure reasons of clutch release Low Price SKF 608 Bearing

Clutch release bearing damage and the driver's operation and maintenance, the adjustment has much to do, the damage reason to roughly the following:

1) working temperatures cause overheating

Many drivers in turn or slow, often a half step clutch, some shift hind feet still on the clutch pedal. Some vehicles free stroke adjustment is too large, to separate the clutch is not completely, in joint and separation condition, the dry friction caused by the state of this and produce a large amount of heat transfer to the release bearing, bearing is heated to a certain temperature, melt the butter or dilute flow, make the separation bearing temperature rise further, when the temperature reaches a certain extent it burn out.


2) lack of lubricating oil and wear

Clutch release bearing lubrication in butter, butter to join, there are two ways for 360111 release bearing, should be in the maintenance or remove the transmission, fill open rear cover of the bearing grease, then the back cover to fit up; For 788611 k release bearing, it can tear it down in the molten grease dip cooked, take out after cooling, can achieve the purpose of lubrication. Driver is easy in the practical work, which is blind to this point, cause the clutch release bearing short of oil. In separation without lubrication or less lubrication bearing lubrication and is often worn after several times to dozens times the amount of wear and tear. Wear increases, the temperature will also have greatly improved, and thus are more likely to be damaged.

3) free stroke is too small or too many loaded

According to requirements, the clearance between the separation between the lever and the clutch release bearing is more suitable for 2.5 mm, reflect on the clutch pedal free stroke for 30 to 40 mm, free stroke is too small or no free stroke, will make separate lever and is often joint state of release bearing. According to the principle of fatigue damage, the bearing working time long, the more serious damage. Under load, the more isolated bearing is easy to produce fatigue damage. And the longer you work, bearing the higher the temperature is, the easier it is burning, reduces the service life of the release bearing.


4) in addition to the above three reasons, split the lever to adjust whether level off, the release bearing return spring is good, has a great influence on the release bearing damage also.

Tutor Answer

(Top Tutor) Daniel C.
School: UT Austin
Studypool has helped 1,244,100 students
Ask your homework questions. Receive quality answers!

Type your question here (or upload an image)

1821 tutors are online

Related Business & Finance questions


Brown University

1271 Tutors

California Institute of Technology

2131 Tutors

Carnegie Mellon University

982 Tutors

Columbia University

1256 Tutors

Dartmouth University

2113 Tutors

Emory University

2279 Tutors

Harvard University

599 Tutors

Massachusetts Institute of Technology

2319 Tutors

New York University

1645 Tutors

Notre Dam University

1911 Tutors

Oklahoma University

2122 Tutors

Pennsylvania State University

932 Tutors

Princeton University

1211 Tutors

Stanford University

983 Tutors

University of California

1282 Tutors

Oxford University

123 Tutors

Yale University

2325 Tutors