Paraphrasing a page word by word bcz they got caught up by turn it in

User Generated

ffee7755

Writing

Description

I need u to just paraphrase the attached document word, by rewriting it word by word in other ways or just use synonyms for em,, Don't use any not orginal senteces from the internet bcz i'll be caught up

Unformatted Attachment Preview

Paraphrase them totally word by word The objectives of this lab experiment are to determine the time-constant of a first order system by means of monitoring the transient response. It is also to determine the bandwidth of a first order system by means of monitoring the steady state response The RC circuit is a typical example of the first order system. In this first order system, the time constant is given by In the first section of the experiment of evaluating the time-constant for a first order system by observing the transient response, the circuit shown in Figure 3 below was constructed, and a digital multimeter was used to accurately record and measure the resistance of the 100kΩ and 56kΩ resistors and the capacitances of the two 1𝜇𝐹 capacitors. Then, the circuit was examined momentarily by means of connecting the non-inverting input (pin 3) of the first op-amp with the +5V rail and the +5V removed while the left LEDs lighted up. After this, a 0.5 Hz square wave with a ±5𝑉 amplitude was generated using the generator of the waveform function and checked by the oscilloscope in order to make sure that the signal has a zero average and has a 0.5 Hz frequency. After that, the square wave signal was applied to the input of the circuit shown below to observe that the two pairs of LEDs (two Left and two Right) light up with the alternating square wave signal In the second section of the experiment of evaluating the Bandwidth of a first order system by observing the steady state response, the system was reset to the initial 156 kΩ resistor configuration and the two 1 𝜇𝐹 capacitors were in parallel. Then, the generator of function output was set to provide with a 0.1 Hz sine wave plus a 5V amplitude and checked using the oscilloscope to ensure it has a zero average he Description of how the LED turns on and off during the different circuit In the second section of the experiment of evaluating the Bandwidth of a first order system by observing the steady state response, the angular frequency, the gain, and the phase lag were calculated by using Eq…. This lab experiment has shown that the time-constant of a first order system can be determined by observing the transient response and that the bandwidth of a first order system can be determined by observing the steady state response
Purchase answer to see full attachment
User generated content is uploaded by users for the purposes of learning and should be used following Studypool's honor code & terms of service.

Explanation & Answer

Attached.

Running head: THE RESISTOR AND CAPACITOR CIRCUIT

The Resistor and Capacitor Circuit
Student’s Name:
Institutional Affiliation

1

THE RESISTOR AND CAPACITOR CIRCUIT

2

These lab experiments are carried out objectively to verify the time-constant of a first sort
system by means of observing the transient reaction as well as determining the energy capacity
of the system by observing the response. This involves the use of simple tools, multimeter, and a
digital stopwatch to acc...


Anonymous
I was stuck on this subject and a friend recommended Studypool. I'm so glad I checked it out!

Studypool
4.7
Trustpilot
4.5
Sitejabber
4.4

Similar Content

Related Tags